I fixed up a couple of Spear and Jackson saws from the 60’s this week and finished them off today. You can buy these on eBay for around £25 (sometimes less) and at first glance you may discard the option to buy. Taking stock of the overall qualities of these dead ugly looking saws may well lead to a fine saw that will serve you for a lifetime. I own one of these saws from my apprenticeship days and bought it new in 1967. That makes it 45 years old. Now mine, in storage in the USA, is 1 1/2″ narrower than these I have fixed up because I have used it every day throughout my working life and I have sharpened every other week throughout that time. It has indeed been a good saw and I see them all the time on eBay. In fact I just bought another for £3.99 Buy it Now plus £3.00 shipping alongside a number 4 for £5 plus £3.80 shipping.
Before above and after below
I began with the plate and polished the steel taking it from 250-grit through 2500-grit. I repeated this on the brass back and then polished it on a cotton wheel. The brass nuts polished up quickly too. Now mine were solid brass and typical of that era of cheapening materials when subsequent to that they ended up plated instead of solid. Pathetic really.
Use them as a kit
Note here that I have not replaced either handle but simply shaped and refined the designs. These saws are quite lovely now that I have sharpened them. I will likely sell one of them to my students over the weeks when I return.
5 Comments
I wish I had your skill / luck with finding things on ebay Paul. First dibs on the saw if you’re selling it in the US.
Paul
What type and size of Saw File do you need for sharpening a tenon saw
Regards
David
That depends on the size of the saw’s teeth. Most tenon saws are around 15 points per inch (PPI). In this case an 4-6″ XX Slim taper file works well and will handle most small saw filing. Teeth with 22 PPI will need a smaller 4″ file. Even though many people think that you can use larger files for smaller teeth of this size, that’s not the case all the time. People think that files are three sided when in fact they are six sided; 3 larger facets and 3 very small where the larger facets would come to the corner if that were practical.
I have a 48 inch spear an jackson 2 man vintage saw in great condition how much should i be asking for it please
You must enter certain information to submit the form on this page. We take the handling of personal information seriously and appreciate your trust in us. Our Privacy Policy sets out important information about us and how we use and protect your personal data and it also explains your legal rights in respect of it. Please click here to read it before you provide any information on this form.
I wish I had your skill / luck with finding things on ebay Paul. First dibs on the saw if you’re selling it in the US.
Paul
What type and size of Saw File do you need for sharpening a tenon saw
Regards
David
That depends on the size of the saw’s teeth. Most tenon saws are around 15 points per inch (PPI). In this case an 4-6″ XX Slim taper file works well and will handle most small saw filing. Teeth with 22 PPI will need a smaller 4″ file. Even though many people think that you can use larger files for smaller teeth of this size, that’s not the case all the time. People think that files are three sided when in fact they are six sided; 3 larger facets and 3 very small where the larger facets would come to the corner if that were practical.
I have a 48 inch spear an jackson 2 man vintage saw in great condition how much should i be asking for it please
Hayden I would contact http://www.thisoldchainsaw.com, has helped me on a couple saws I later sold.